|
Hands FREE way to record
ONLY the moments you want whether you’re home or
not!
NEW! Just Released! Now you can
set your XCam2 and VCR
on auto-pilot to "Record ONLY the
action" in and around your home totally hands free! It's
the NEW VCR Commander II Kit.
Whether you're home or not, when motion is detected, this amazing
product can turn on the appropriate Camera and your VCR - then
automatically send a "Record" command to your VCR!
VCR Commander
II also works with multiple
camera systems (system expandable to 16+ cameras). If a person
starts walking around your
house, as they enter Zone 1 the camera monitoring Zone 1 will turn
on, and the VCR Commander II starts
your VCR recording. As they enter Zone 2, the second camera will
turn on (camera 1 will turn off) and the VCR will continue to record
what's happening in Zone 2. As the person completes a trip around
your home (ex. visiting Zones 1-4), the tape will show everything as
they move between all four zones.
NEW - LEARNS
MOTION SENSOR CODES! The VCR Commander II allows you to learn
motion sensor codes (see control panel on right), so you can have
the same motion sensor turn on a camera & turn on/record the
VCR. (Solves the problem of needing double motion sensors; 1
for camera, 1 for VCR Commander)
When no motion has been detected from the
motion detector for 5 minutes - the VCR Commander
II will turn the VCR OFF or STOP recording. This will
make sure your tape only shows the action and reduces the amount of
blank, no action time.
NEW - HOME &
AWAY MODE! The VCR Commander II allows you to operate in a
home & away mode. In "away" mode, the VCR Commander will
turn on the VCR and record the action based on being activated by a
motion sensor. In "home" mode, when motion is detected - instead of
turning on the VCR and recording, the VCR Commander will chime, to
let you know about the action.
Record ONLY the Action:
Imagine going on a 2 week vacation with the family. When you get
home, turn on the VCR and watch everything the happened around your
home while you were away. Someone try to visit you? Someone try to
break in? Who smashed the mailbox? It's all on
tape!
 How it works &
directions for setup The new VCR Commander learns a
sequence of up to 4 different IR commands (labeled PWR, REC,
PLAY, and STOP) and up to 4 different motion sensor signals.
You teach the IR commands by selecting the button on the
VCR Commander
II (UX23A) to learn for and then using the VCR remote
control to emit that command to the VCR Commander II.
Learning motion sensor codes is done in a similar
manner.
When the On command from the programmed address is received, the VCR Commander
II will issue the programmed IR sequence to the VCR
through the IR emitter cable. More On commands (signals of further
motion) within 5 minutes will be ignored. If no more On commands are
seen within 5 minutes (no further motion), the VCR
Commander II will issue the IR “Stop” command. After
the “Stop” command is issued an On command will start the cycle over
again. Because of this, it is recommended that you shouldn’t use the
“PWR” command as part of their record sequence, and should instead
leave their VCR on all the time.
Parts of the kit without camera:
(This kit was designed for someone that already owns an XCam2 camera
and VCR. If you do not own an XCam2 Camera yet, please see 3 Camera
Deal below)
Note: You must also have a VCR for
this product to work.
|